| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VIXI |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - ] |
| Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR(for AWD): REMOVAL; 2016 - 2020 MY Sienna [12/2015 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the LH side and RH side.
- The following procedure is for the LH side.
- If the sensor rotor needs to be replaced, replace it together with the rear drive shaft assembly.
PROCEDURE
1. SEPARATE BACK DOOR WEATHERSTRIP
2. REMOVE BACK DOOR SCUFF PLATE
![2016 - 2017 MY Sienna [12/2015 - 11/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+](/t3Portal/stylegraphics/info.gif)
3. REMOVE REAR DOOR SCUFF PLATE
4. SEPARATE SLIDE DOOR WEATHERSTRIP
5. SEPARATE REAR NO. 2 SEAT OUTER BELT ASSEMBLY
6. REMOVE QUARTER TRIM PANEL ASSEMBLY
7. REMOVE REAR WHEEL
8. REMOVE REAR SPEED SENSOR
|
(a) Disconnect the rear speed sensor connector. |
|
|
(b) Remove the 2 clips and peel back the rear wheel house liner. HINT: Peel back the rear wheel house liner enough to allow removal and installation of the rear speed sensor. |
|
|
(c) Disconnect the grommet of the rear speed sensor wire from the hole of the wheel house. Text in Illustration
|
|
|
(d) Remove the 2 bolts, No. 1 bracket and No. 2 bracket from the body and rear axle beam. Text in Illustration
|
|
|
(e) Remove the bolt and rear speed sensor from the retainer. NOTICE: Keep the sensor tip and rear speed sensor installation hole free from foreign matter. |
|
|
|