Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000000VIXF |
Model Year Start: 2016 |
Model: Sienna |
Prod Date Range: [12/2015 -
] |
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR(for 2WD): REMOVAL; 2016 - 2020 MY Sienna [12/2015 - ] |
REMOVAL
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
-
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly
-
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
PROCEDURE
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
4. REMOVE REAR DISC
5. DISCONNECT SKID CONTROL SENSOR WIRE
6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
(a) Remove the 4 nuts and hub and bearing assembly.
HINT:
-
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
-
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
|
|
7. REMOVE REAR INNER AXLE BEARING RETAINER
|