| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VIVK |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - 11/2017] |
| Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light does not Come ON; 2016 - 2017 MY Sienna [12/2015 - 11/2017] | ||
|
Slip Indicator Light does not Come ON |
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN communication.
WIRING DIAGRAM
Refer to SLIP Indicator Light Remains ON (See page
![2016 MY Sienna [12/2015 - 08/2016]; BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light Remains ON+](/t3Portal/stylegraphics/info.gif)
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration and store system information (See page
).
PROCEDURE
|
1. |
CHECK CAN COMMUNICATION SYSTEM |
(a) Check if a CAN communication system DTC is output (See page
).
Result
|
Result |
Proceed to |
|---|---|
|
DTC is not output |
A |
|
DTC is output |
B |
| B |
|
INSPECT CAN COMMUNICATION SYSTEM (See page
|
|
|
2. |
PERFORM ACTIVE TEST USING TECHSTREAM (SLIP INDICATOR LIGHT) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
(e) Select the Active Test on the Techstream.
ABS/VSC/TRAC
|
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Slip Indicator Light |
SLIP indicator light |
Indicator light ON / OFF |
Observe combination meter |
(f) Check that the SLIP indicator light on the combination meter turns on or off in accordance with the Techstream operation.
OK:
The SLIP indicator light turns on or off in accordance with the Techstream operation.
HINT:
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See page
).
| OK |
|
|
|
3. |
PERFORM ACTIVE TEST USING TECHSTREAM (SLIP INDICATOR LIGHT) |
(a) Reconnect the skid control ECU connector.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Combination Meter / Active Test.
(f) Select the Active Test on the Techstream.
Combination Meter
|
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Indicat. Lamp Slip |
SLIP indicator light |
OFF or ON |
Operate with IG ON and the vehicle stopped |
(g) Check that the SLIP indicator light on the combination meter turns on or off in accordance with the Techstream operation.
OK:
The SLIP indicator light turns on or off in accordance with the Techstream operation.
HINT:
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step (See page
).
| OK |
|
| NG |
|
|
|