Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VIUS
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 - 08/2016]
Title: TIRE / WHEEL: TIRE AND WHEEL SYSTEM: INSPECTION; 2016 MY Sienna [12/2015 - 08/2016]

INSPECTION

PROCEDURE

1. INSPECT TIRES

(a) Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:

Tire Size

Front

kPa (kgf/cm2, psi)

Rear

kPa (kgf/cm2, psi)

P235/60R17 100T

P235/55R18 99V

P235/55RF18 99T

240 (2.4, 35)

240 (2.4, 35)

P235/50R19 99V

250 (2.5, 36)

250 (2.5, 36)

(b) Using a dial indicator, check the runout of the tires.

Maximum tire runout:

1.4 mm (0.0551 in.)

2. ROTATE TIRES

(a) Rotate the tires as shown in the illustration.

Text in Illustration

*a

Front

3. INSPECT WHEEL BALANCE

(a) Check and adjust the off-the-car balance.

Maximum wheel imbalance after adjustment:

8.0 g (0.0176 lb)

NOTICE:

  • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
  • Do not touch the sticking surface of the tape.
  • Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

    Width (A):

    25 mm (0.984 in.)

  • Push the balance weight securely with your finger to adhere it to the position.
  • Do not reuse the balance weight.
  • Use the TOYOTA genuine sticking type balance weights.

HINT:

The inner side balance weight should be installed by clipping it to the rim.

4. INSPECT FRONT AXLE HUB

(See page 2016 - 2020 MY Sienna [12/2015 -        ]; AXLE AND DIFFERENTIAL: FRONT AXLE HUB: ON-VEHICLE INSPECTION )

5. INSPECT REAR AXLE HUB

(See page 2016 - 2020 MY Sienna [12/2015 -        ]; AXLE AND DIFFERENTIAL: REAR AXLE HUB: ON-VEHICLE INSPECTION )