| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VITV |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - ] |
| Title: TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: TC and CG Terminal Circuit; 2016 - 2020 MY Sienna [12/2015 - ] | ||
|
TC and CG Terminal Circuit |
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are indicated by the blinking of the tire pressure warning light.
WIRING DIAGRAM
HINT:
When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
CAUTION / NOTICE / HINT
NOTICE:
- When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
-
It is necessary to perform initialization (See page
![2016 - 2020 MY Sienna [12/2015 - ]; TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
) after registration (See page
) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or tire pressure warning valve and transmitter has been replaced.
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (DLC3 - ECU AND BODY GROUND) |
(a) Disconnect the D82 ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
D82-3 (TC) - D16-13 (TC) |
Always |
Below 1 Ω |
|
D82-3 (TC) - Body ground |
Always |
10 kΩ or higher |
|
D16-4 (CG) - Body ground |
Always |
Below 1 Ω |
| OK |
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|