INSTALLATION

PROCEDURE

1. INSTALL FRONT STABILIZER BAR

(a) Install the front stabilizer bar from the left side of the vehicle.

2. INSTALL FRONT NO. 1 STABILIZER BAR BUSHING

(a) Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration. Text in Illustration *a Cutout *b Front of the Vehicle *c Inside of the Vehicle NOTICE: When installing the front No. 1 stabilizer bar bushings, make sure that the cutout faces the rear of the vehicle.

3. INSTALL FRONT NO. 2 STABILIZER BRACKET LH

(a) Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

4. INSTALL FRONT NO. 2 STABILIZER BRACKET RH

HINT:

Perform the same procedure as the LH side.

5. INSTALL FRONT NO. 1 STABILIZER BRACKET LH

(a) Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.

Torque:

33 N·m {337 kgf·cm, 24 ft·lbf}

6. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:

Perform the same procedure as the LH side.

7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

(a) Install the front stabilizer link assembly LH with the 2 nuts.

Torque:

for Upper Side :

130 N·m {1326 kgf·cm, 96 ft·lbf}

for Lower Side :

74 N·m {755 kgf·cm, 55 ft·lbf}

HINT:

If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

8. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as the LH side.

9. INSTALL FRONT EXHAUST PIPE ASSEMBLY

10. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET

11. INSTALL EXHAUST MANIFOLD TO HEAD GASKET

(See page )

12. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

(See page )