| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VINL |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - 08/2016] |
| Title: U660F (AUTOMATIC TRANSMISSION / TRANSAXLE): AUTOMATIC TRANSAXLE SYSTEM: P062F; Internal Control Module EEPROM Error; 2016 MY Sienna [12/2015 - 08/2016] | ||
|
DTC |
P062F |
Internal Control Module EEPROM Error |
DESCRIPTION
The TCM monitors its internal operation and it will set this DTC when it detects an internal malfunction.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
P062F |
TCM internal error (EEPROM) |
TCM |
MONITOR DESCRIPTION
The TCM monitors its internal operation. If the internal operation is malfunctioning, the TCM will turn on the MIL and store the DTC.
MONITOR STRATEGY
|
Related DTCs |
P062F: Internal control module EEPROM error |
|
Required sensors/Components (Main) |
TCM |
|
Required sensors/Components (Related) |
- |
|
Frequency of operation |
Once per driving cycle |
|
Duration |
11 seconds |
|
MIL operation |
Immediate |
|
Sequence of operation |
None |
TYPICAL ENABLING CONDITIONS
|
Monitor runs whenever following DTCs not present |
None |
|
Time after engine start |
10 seconds or more |
|
Battery voltage |
8 V or higher |
|
Ignition switch |
ON |
|
Starter |
OFF |
TYPICAL MALFUNCTION THRESHOLDS
|
Permanent fault code data |
Mismatch (3 times or more) |
CAUTION / NOTICE / HINT
NOTICE:
-
Perform the universal trip to clear permanent DTCs (See page
![2016 MY Sienna [12/2015 - 08/2016]; U660F (AUTOMATIC TRANSMISSION / TRANSAXLE): AUTOMATIC TRANSAXLE SYSTEM: DTC CHECK / CLEAR](/t3Portal/stylegraphics/info.gif)
).
- There is a possibility that the DTC P062F is issued from the ECUs of the ECM and TCM. Use Techstream to conduct a health check to confirm which ECU the DTC is issued from and then inspect the related system.
PROCEDURE
|
1. |
READ OUTPUT DTC (DTC P062F) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Clear DTCs (See page
).
(e) Turn the ignition switch off and turn the Techstream off.
(f) Disconnect the Techstream.
(g) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
(h) Connect the cable to the negative (-) battery terminal.
(i) Connect the Techstream to the DLC3.
(j) Turn the ignition switch to ON.
(k) Turn the Techstream on.
(l) Enter the following menus: Powertrain / ECT / Trouble Codes.
(m) Read DTCs.
Result
|
Result |
Proceed to |
|---|---|
|
No DTC output |
A |
|
P062F is output |
B |
| A |
|
| B |
|
|
|