Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VIKY
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 - 08/2016]
Title: U660E (AUTOMATIC TRANSMISSION / TRANSAXLE): AUTOMATIC TRANSAXLE SYSTEM: P0560; System Voltage; 2016 MY Sienna [12/2015 - 08/2016]

DTC

P0560

System Voltage

DESCRIPTION

The battery supplies electricity to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history and freeze frame data. If the battery voltage falls below a minimum level, these memories are cleared and the TCM determines that there is a malfunction in the power supply circuit. When the engine is next started, the TCM will turn on the MIL and store the DTC.

DTC No.

DTC Detection Condition

Trouble Area

P0560

Open in TCM back-up power source circuit.

DTC is detected for 3 seconds or more (1 trip detection logic).
  • Open in back-up power source circuit
  • TCM

HINT:

If DTC P0560 is set, the TCM does not store other DTCs.

MONITOR STRATEGY

Related DTCs

P0560: TCM system voltage

Required Sensors/Components (Main)

TCM

Required Sensors/Components (Sub)

-

Frequency of Operation

Continuous

Duration

3 seconds

MIL Operation

Immediately (MIL illuminated after next engine start)

Sequence of Operation

None

TYPICAL ENABLING CONDITIONS

Monitor runs whenever following DTCs are not present:

None

TYPICAL MALFUNCTION THRESHOLDS

Continuous battery voltage

Less than 3.5 V

Stand-by RAM

Initialized

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  • Perform the universal trip to clear permanent DTCs (See page 2016 MY Sienna [12/2015 - 08/2016]; U660E (AUTOMATIC TRANSMISSION / TRANSAXLE): AUTOMATIC TRANSAXLE SYSTEM: DTC CHECK / CLEAR ).

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (TCM - BATTERY AND BODY GROUND)

(a) Disconnect the TCM connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

B2-1 (BATT) - B2-8 (E1)

Always

11 to 14 V

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

B2-8 (E1) - Body ground

Always

Below 1 Ω

Text in Illustration

*a

Front view of wire harness connector:

(to TCM)
OK

REPLACE TCM

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR