| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VIII |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - 11/2017] |
| Title: CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: Cruise SET Indicator Light Circuit; 2016 - 2017 MY Sienna [12/2015 - 11/2017] | ||
|
Cruise SET Indicator Light Circuit |
DESCRIPTION
- The ECM turns on the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication.
- The cruise control SET indicator illuminates when the dynamic radar cruise control system is controlling vehicle speed.
- The cruise control SET indicator circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
CAUTION / NOTICE / HINT
NOTICE:
When the ECM is replaced with a new one, initialization must be performed (See page
![2016 MY Sienna [12/2015 - 08/2016]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
).
PROCEDURE
|
1. |
PERFORM ACTIVE TEST USING TECHSTREAM (METER DISPLAY 1) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.
(e) Check the cruise control SET indicator by performing the Active Test.
Combination Meter
|
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Meter Display 1 |
Cruise control SET indicator |
OFF or All |
- |
OK:
Cruise control SET indicator turns on/off.
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (See page
|
| NG |
|
|
|