Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000000VIHV |
Model Year Start: 2016 |
Model: Sienna |
Prod Date Range: [12/2015 - 08/2016] |
Title: CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: TC and CG Terminal Circuit; 2016 MY Sienna [12/2015 - 08/2016] |
TC and CG Terminal Circuit
|
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the system to enter the self-diagnostic mode. If a malfunction is present, the MIL will blink.
HINT:
When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.
WIRING DIAGRAM
PROCEDURE
1.
|
CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - ECM)
|
(a) Disconnect the ECM connector.
|
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A39-16 (TC) - D16-13 (TC)
|
Always
|
Below 1 Ω
|
Text in Illustration
*a
|
DLC3
|
*b
|
Front view of wire harness connector
(to ECM)
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
OK
|
|
|
2.
|
CHECK HARNESS AND CONNECTOR (TERMINAL CG of DLC3 - BODY GROUND)
|
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
D16-4 (CG) - Body ground
|
Always
|
Below 1 Ω
|
Text in Illustration
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
OK
|
|
|
3.
|
CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - BODY GROUND)
|
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
D16-13 (TC) - Body ground
|
Always
|
10 kΩ or higher
|
Text in Illustration
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU
|
|