Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VIHS
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 - 11/2017]
Title: CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: Cruise Main Indicator Light Circuit; 2016 - 2017 MY Sienna [12/2015 - 11/2017]

Cruise Main Indicator Light Circuit

DESCRIPTION

When the cruise control main switch is turned on, the cruise main indicator and "Radar Ready" come on. This indicates the control condition (presence or absence of a vehicle in front, vehicle-to-vehicle distance, and set vehicle speed) and fail-safe state through the CAN communication system. The master warning light and cruise main indicator come on and vehicle-to-vehicle distance information is displayed on the combination meter assembly as the alarm buzzer sounds. Items such as "Dynamic Radar Cruise Sensor Needs Cleaning", "Dynamic Radar Cruise Not Available" and "Check Cruise Control System" are displayed on the multi-information display on the combination meter assembly when the ECM detects signals from each sensor and actuator and sends them to the combination meter assembly via CAN.

HINT:

If the vehicle in front in the same lane significantly decreases vehicle speed or another vehicle moves in front of your vehicle, adequate deceleration cannot be applied and the vehicle-to-vehicle distance will shorten. At this time, the system sounds the buzzer to warn the driver. Each indicator in the dynamic radar cruise control uses CAN for communication. Therefore, if there are any malfunctions in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

PROCEDURE

1.

PERFORM ACTIVE TEST USING TECHSTREAM (METER DISPLAY1)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.

(e) Check the cruise main indicator by performing the Active Test.

Combination Meter

Tester Display

Measurement Item

Control Range

Diagnostic Note

Meter Display 1

Cruise main indicator (Constant speed control mode)

Cruise main indicator (Vehicle-to-vehicle distance control mode)

OFF or All

-

OK:

The display changes in accordance with Active Test operation.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

(See page 2016 MY Sienna [12/2015 - 08/2016]; CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: PROBLEM SYMPTOMS TABLE 2017 MY Sienna [08/2016 - 11/2017]; CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: PROBLEM SYMPTOMS TABLE )

NG

REPLACE COMBINATION METER ASSEMBLY