| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VIGC |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - 08/2016] |
| Title: 2GR-FE LUBRICATION: OIL PUMP: REMOVAL; 2016 MY Sienna [12/2015 - 08/2016] | ||
REMOVAL
PROCEDURE
1. REMOVE ENGINE ASSEMBLY
(See page
![2016 MY Sienna [12/2015 - 08/2016]; 2GR-FE ENGINE MECHANICAL: ENGINE ASSEMBLY: REMOVAL](/t3Portal/stylegraphics/info.gif)
)
2. REMOVE IGNITION COIL ASSEMBLY
3. REMOVE CRANKSHAFT POSITION SENSOR
4. REMOVE NO. 1 OIL PIPE
5. REMOVE OIL PIPE
6. REMOVE CRANKSHAFT PULLEY
7. SEPARATE OIL COOLER PIPE (w/ oil cooler)
|
(a) Remove the bolt and 2 nuts, and disconnect the oil cooler pipe from the oil pan sub-assembly. |
|
(b) Remove the gasket from the oil pan sub-assembly.
8. REMOVE WATER INLET HOUSING
9. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY (for Bank 1)
10. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY (for Bank 2)
11. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY
12. REMOVE OIL STRAINER SUB-ASSEMBLY
13. REMOVE OIL PAN SUB-ASSEMBLY
14. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY
|
(a) Remove the 23 bolts and 2 nuts shown in the illustration. Text in Illustration
|
|
|
(b) Remove the timing chain cover by prying between the timing chain cover and cylinder head or cylinder block with a screwdriver. Text in Illustration
NOTICE: Be careful not to damage the contact surfaces of the cylinder head, cylinder block and chain cover. HINT: Tape the screwdriver tip before use. |
|
|
(c) Remove the gasket. |
|
15. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL
|
(a) Using a screwdriver, pry out the oil seal. Text in Illustration
HINT: Tape the screwdriver tip before use. |
|
|
|