Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000000VIE1 |
Model Year Start: 2016 |
Model: Sienna |
Prod Date Range: [12/2015 - 08/2016] |
Title: 2GR-FE FUEL: FUEL SENDER GAUGE ASSEMBLY: REMOVAL; 2016 MY Sienna [12/2015 - 08/2016] |
REMOVAL
PROCEDURE
1. DISCHARGE FUEL SYSTEM PRESSURE
2. REMOVE CHARCOAL CANISTER PROTECTOR
3. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
4. DRAIN FUEL
5. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 2WD)
6. REMOVE NO. 1 FUEL TANK HEAT INSULATOR (for 2WD)
7. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for AWD)
(See page
)
8. DISCONNECT FUEL TANK VENT HOSE
9. DISCONNECT CHARCOAL CANISTER OUTLET TUBE SUB-ASSEMBLY
10. REMOVE REAR FLOOR NO. 2 CROSSMEMBER BRACE LH
11. REMOVE FUEL TANK FILLER HOSE COVER
12. REMOVE FUEL TANK ASSEMBLY
13. REMOVE FUEL TANK TO FILLER PIPE HOSE
14. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
(a) Widen the tip of the tube joint clip and pull out the clip in the direction indicated by the arrow.
Text in Illustration
*1
|
Tube Joint Clip
|
*2
|
Fuel Tube Connector
|
*3
|
O-Ring
|
|
Pull Out
|
|
Pull
|
NOTICE:
-
Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
-
The fuel tube connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
-
Do not use any tools.
-
Do not bend or twist the tubes.
-
Protect the contact surface by covering it with a plastic bag.
-
If the connector is stuck, push and pull on the parts to separate them.
(b) Pull the fuel tank main tube out of the fuel suction with pump and gauge tube assembly to disconnect it.
15. REMOVE FUEL PUMP GAUGE RETAINER
16. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
17. REMOVE FUEL SUCTION TUBE SET GASKET
18. REMOVE FUEL SENDER GAUGE ASSEMBLY
(a) Disconnect the fuel sender gauge connector and disengage the harness clamp.
NOTICE:
Do not damage the wire harness.
|
|
(b) Release the lock as shown in the illustration and remove the fuel sender gauge by sliding it.
|
|
|