Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VIDG
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 - 08/2016]
Title: 2GR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION; 2016 MY Sienna [12/2015 - 08/2016]

INSTALLATION

PROCEDURE

1. INSTALL ENGINE REAR OIL SEAL

(a) Apply MP grease to a new engine rear oil seal lip.

Text in Illustration

*1

Retainer

*a

Oil seal tap in depth

(-0.5 to 0.5 mm)

(b) Using SST and a hammer, tap in the engine rear oil seal.

SST: 09223-15030

SST: 09950-70010

09951-07150

Oil seal tap in depth:

-0.5 to 0.5 mm (-0.0196 to 0.0196 in.)

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

(a) Using SST, hold the crankshaft pulley.

SST: 09213-70011

09213-70020

SST: 09330-00021

(b) Clean the 8 bolts and 8 bolt holes.

(c) Install the front drive plate spacer.

HINT:

Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

(d) Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

Text in Illustration

*1

Drive Plate

*2

Rear Spacer

Transaxle Side

(e) Apply adhesive to 2 or 3 threads of the 8 bolts.

Text in Illustration

*1

Adhesive

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(f) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

Torque:

83 N·m {846 kgf·cm, 61 ft·lbf}

NOTICE:

Do not start the engine for at least an hour after installing the drive plate.

3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)

(See page 2016 MY Sienna [12/2015 - 08/2016]; U660E (AUTOMATIC TRANSMISSION / TRANSAXLE): AUTOMATIC TRANSAXLE ASSEMBLY(When Not Using the Engine Support Bridge): INSTALLATION )

4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)

(See page 2016 MY Sienna [12/2015 - 08/2016]; U660F (AUTOMATIC TRANSMISSION / TRANSAXLE): AUTOMATIC TRANSAXLE ASSEMBLY(When Not Using the Engine Support Bridge): INSTALLATION )