| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VI8I |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - 08/2016] |
| Title: 2GR-FE (ENGINE CONTROL): ACTIVE CONTROL ENGINE MOUNT: ON-VEHICLE INSPECTION; 2016 MY Sienna [12/2015 - 08/2016] | ||
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FRONT ENGINE MOUNTING INSULATOR ASSEMBLY
(a) Check the operation.
(1) Connect the Techstream to the DLC3.
(2) Start the engine.
(3) Turn the Techstream on.
(4) Enter the following menus: Powertrain / Engine / Active Test / Control the ACM Inhibit.
|
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Control the ACM Inhibit |
ACM |
ON / OFF |
Test is possible while engine is idling |
(5) Check if the front engine mounting insulator assembly operates in accordance with tester operation.
OK:
|
Condition |
Specified Condition |
|---|---|
|
"Control the ACM Inhibit" is OFF |
The engine does not move (insulator operation is normal). |
|
"Control the ACM Inhibit" is ON |
The engine moves in accordance with insulator operation. |
HINT:
While "Control the ACM Inhibit" is ON, the front engine mounting insulator assembly operates repeatedly.
(b) Inspect for vacuum leaks.
(1) Disconnect the vacuum hose from the front engine mounting insulator assembly.
|
(2) Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 24 in.Hg) and wait for 1 minute. |
|
(3) Check that there is no change in the needle movement of the vacuum pump gauge.
OK:
Vacuum pressure holds.
(4) Check that there is no fluid leakage caused by a break in the diaphragm.
(5) Reconnect the vacuum hose.
|
|