Front Side Door Window Replacement

Warning: Refer to Glass and Sheet Metal Handling Warning.

Removal Procedure
  1. Adjust the window 3-4 inches open from the top.

    2. Object ID: 6354142

    Note: Quantity of fasteners may vary based on option content.

  2. Roof Panel Joint Finish Molding Nut(1)»Remove[2x]

    3. Object ID: 6196694
  3. Roof Panel Joint Front Finish Molding Retainer(1)»Release[8x]

    4. Object ID: 5875928
  4. Roof Panel Joint Finish Molding Front End Cap(1)»Remove
  5. Place the front side door in the full open position.

    6. Object ID: 5880865
  6. Front Side Door Inner Guide Bolt(1)»Remove[4x]

    7. Object ID: 5880862
  7. Front Side Door Inner Guide(1)»Remove

    8. Object ID: 5880896
  8. Front Side Door Guide Bolt(1)»Remove[4x]

    9. Object ID: 5880881
  9. Front Side Door Guide(1)»Remove

    10. Object ID: 5880943
  10. Front Side Door Guide Molding Bolt(1)»Remove[4x]

    11. Object ID: 5880947
  11. Front Side Door Guide Molding(1)»Remove

    12. Object ID: 5890813
  12. Roof Side Rail Bolt(1)»Remove

    13. Object ID: 5890812
  13. Roof Side Rail Bolt(1)»Remove

    14. Object ID: 5890815
  14. Roof Side Rail Bolt(1)»Remove

    15. Object ID: 5891718
  15. Roof Side Rail Outer Extension (1)»Remove
  16. Close the door enough to gain access to the door slide bolts.

    17. Object ID: 5877952
  17. Using a flat bladed plastic trim tool, release the retaining clips.
  18. Center Pillar Upper Trim Panel(3)»Reposition

    19. Object ID: 5892326
  19. Electrical Connector(1)»Disconnect

    20. Object ID: 5893510
  20. Mark the location of the front side door roller bolts (1) with a grease pencil to aid in alignment during installation.
  21. Front Side Door Roller Bolt(1)»Remove[6x]

    22. Object ID: 5890823
  22. Disconnect the wiring harness retainers as necessary.
  23. With the aid of an assistant, remove the front side door.(1)

    24. Object ID: 5879399
  24. Front Side Door Hinge Pin(1)»Remove
  25. Front Side Door Inner Panel Energy Absorber Bolt(2)»Remove[14x]

    26. Object ID: 5879401
  26. Front Side Door Inner Front Panel(1)»Remove

    27. Object ID: 5928778
  27. Front Side Door Window Channel Retainer Bolt (1)»Remove[2x]
  28. Front Side Door Window Channel Retainer (2)»Remove

    29. Object ID: 5929378
  29. Front Side Door Window Bolt(1)»Release[2x]
  30. Lift the front side door window from the sash clips and tape the front side door window in the full up position.

    31. Object ID: 5929561
  31. Disconnect the electrical connector.

    32. Object ID: 5929554
  32. Front Side Door Window Regulator Bolt(1)»Remove[5x]

    33. Object ID: 5929564
  33. Front Side Door Window Regulator(1)»Remove

    34. Object ID: 5932145
  34. Remove the tape from the window (1) and lower the window all the way down into the door.

    35. Object ID: 5932156
  35. Starting in the upper corner pull the front side door window inner weatherstrip (1) down and out from the door.

    36. Object ID: 5932157
  36. Starting in the upper corner pull the front side door window weatherstrip (1) down and out from the door.

    37. Object ID: 5932158
  37. Remove the front side door window channel lower adjuster access hole plug (1).

    38. Object ID: 5932148
  38. Front Side Door Stationary Window Bolt(1)»Remove

    39. Object ID: 5932149
  39. Remove the front side door stationary window upper bolt (1).

    40. Object ID: 5932152
  40. Front Side Door Stationary Window(1)»Remove

    41. Object ID: 5932144
  41. Lift up the front side door window (1) to remove from the door.

    42. Object ID: 5932161
  42. Front Side Door Window(1)»Remove
Installation Procedure

    Object ID: 5932161
  1. Front Side Door Window(1)»Install

    2. Object ID: 5932145
  2. Lower the front side door window (1) down into the door.

    3. Object ID: 5932155
  3. Front Side Door Stationary Window(1)»Install

    4. Object ID: 5932149
  4. Install the front side door stationary window upper bolt (1) and hand tighten.

    5. Object ID: 5932148

    Caution: Refer to Fastener Caution.

  5. Front Side Door Stationary Window Bolt(1)»Install and tighten—Fastener Specifications

    6. Object ID: 5932158
  6. Install the front side door window channel lower adjuster access hole plug (1).

    7. Object ID: 5932157
  7. Front Side Door Window Weatherstrip(1)»Install

    8. Object ID: 5932156
  8. Front Side Door Window Inner Weatherstrip(1)»Install

    9. Object ID: 5932144
  9. Lift the front side door window (1) up into the door and tape in place.

    10. Object ID: 5929564
  10. Front Side Door Window Regulator(1)»Install

    11. Object ID: 5929554
  11. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
    1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
    2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Remove loose debris from internal and external threads using compressed air.
    4. Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation.Adhesives, Fluids, Lubricants, and Sealers
  12. Front Side Door Window Regulator Bolt(1)»Install and tighten[5x]—Fastener Specifications

    13. Object ID: 5929561
  13. Connect the electrical connector.

    14. Object ID: 5929378
  14. Remove the tape holding the front side door window in the full up position and lower the window into the front side door window sash clips.
  15. Front Side Door Window Bolt(1)»Install and tighten[2x]—Fastener Specifications

    16. Object ID: 5928778
  16. Front Side Door Window Channel Front Retainer(2)»Install
  17. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
    1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
    2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Remove loose debris from internal and external threads using compressed air.
    4. Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation.Adhesives, Fluids, Lubricants, and Sealers
  18. Front Side Door Window Channel Front Retainer Bolt (1)»Install and tighten[2x]—Fastener Specifications

    19. Object ID: 5879401
  19. Front Side Door Inner Front Panel(1)»Install

    20. Object ID: 5879399
  20. Front Side Door Inner Panel Energy Absorber Bolt(2)»Install and tighten[14x]—Fastener Specifications
  21. Front Side Door Hinge Pin(1)»Install

    22. Object ID: 5890823
  22. With the aid of an assistant, install the front side door.(1)
  23. Connect the wiring harness retainers as necessary.

    24. Object ID: 5893510
  24. Align the front side door roller bolts (1) with the markings made with the grease pencil.
  25. Front Side Door Roller Bolt(1)»Install and tighten[6x]—Fastener Specifications

    26. Object ID: 5892326
  26. Electrical Connector(1)»Connect

    27. Object ID: 5877952
  27. Center Pillar Upper Trim Panel(3)»Install

    28. Object ID: 5891718
  28. Roof Side Rail Outer Extension (1)»Install

    29. Object ID: 5890815
  29. Roof Side Rail Bolt (1)»Install and tighten—Fastener Specifications

    30. Object ID: 5890812
  30. Roof Side Rail Bolt (1)»Install and tighten—Fastener Specifications

    31. Object ID: 5890813
  31. Roof Side Rail Bolt (1)»Install and tighten—Fastener Specifications

    32. Object ID: 5880947
  32. Front Side Door Guide Molding(1)»Install

    33. Object ID: 5880943
  33. Front Side Door Guide Molding Bolt(1)»Install and tighten[4x]—Fastener Specifications

    34. Object ID: 5880881
  34. Front Side Door Guide(1)»Install

    35. Object ID: 5880896
  35. Front Side Door Guide Bolt(1)»Install and tighten[4x]—Fastener Specifications

    36. Object ID: 5880862
  36. Front Side Door Inner Guide(1)»Install

    37. Object ID: 5880865
  37. Front Side Door Inner Guide Bolt(1)»Install and tighten[4x]—Fastener Specifications

    38. Object ID: 5875928
  38. Roof Panel Joint Finish Molding Front End Cap(1)»Install

    39. Object ID: 6196694
  39. Roof Panel Joint Front Finish Molding Retainer(1)»InstallEngage[8x]

    40. Object ID: 6354142

    Note: Quantity of fasteners may vary based on option content.

  40. Roof Panel Joint Finish Molding Nut(1)»Install and tighten[2x]—Fastener Specifications
  41. Ensure the window system operates properly.