Front Side Door Window Regulator Replacement - Left Side

Warning: Refer to Glass and Sheet Metal Handling Warning.

Removal Procedure

    Object ID: 6354142

    Note: Quantity of fasteners may vary based on option content.

  1. Adjust the window 3-4 inches open from the top.
  2. Roof Panel Joint Finish Molding Nut(1)»Remove[2x]

    3. Object ID: 6196694
  3. Roof Panel Joint Front Finish Molding Retainer(1)»Release[8x]

    4. Object ID: 5875928
  4. Roof Panel Joint Finish Molding Front End Cap(1)»Remove
  5. Place the front side door in the full open position.

    6. Object ID: 5880865
  6. Front Side Door Inner Guide Bolt(1)»Remove[4x]

    7. Object ID: 5880862
  7. Front Side Door Inner Guide(1)»Remove

    8. Object ID: 5880896
  8. Front Side Door Guide Bolt(1)»Remove[4x]

    9. Object ID: 5880881
  9. Front Side Door Guide(1)»Remove

    10. Object ID: 5880943
  10. Front Side Door Guide Molding Bolt(1)»Remove[4x]

    11. Object ID: 5880947
  11. Front Side Door Guide Molding(1)»Remove

    12. Object ID: 5890813
  12. Roof Side Rail Bolt(1)»Remove

    13. Object ID: 5890812
  13. Roof Side Rail Bolt(1)»Remove

    14. Object ID: 5890815
  14. Roof Side Rail Bolt(1)»Remove

    15. Object ID: 5891718
  15. Roof Side Rail Outer Extension (1)»Remove
  16. Close the door enough to gain access to the door slide bolts.

    17. Object ID: 5877952
  17. Using a flat bladed plastic trim tool, release the retaining clips.
  18. Center Pillar Upper Trim Panel(3)»Reposition

    19. Object ID: 5892326
  19. Electrical Connector(1)»Disconnect

    20. Object ID: 5893510
  20. Mark the location of the front side door roller bolts (1) with a grease pencil to aid in alignment during installation.
  21. Front Side Door Roller Bolt(1)»Remove[6x]

    22. Object ID: 5890823
  22. Disconnect the wiring harness retainers as necessary.
  23. With the aid of an assistant, remove the front side door.(1)

    24. Object ID: 5879399
  24. Front Side Door Hinge Pin(1)»Remove
  25. Front Side Door Inner Panel Energy Absorber Bolt(2)»Remove[14x]

    26. Object ID: 5879401
  26. Front Side Door Inner Front Panel(1)»Remove

    27. Object ID: 5928778
  27. Front Side Door Window Channel Retainer Bolt(1)»Remove[2x]
  28. Front Side Door Window Channel Retainer(2)»Remove

    29. Object ID: 5929378
  29. Front Side Door Window Bolt(1)»Release[2x]
  30. Lift the front side door window from the sash clips and tape the front side door window in the full up position.

    31. Object ID: 5929561
  31. Disconnect the electrical connector.

    32. Object ID: 5929554
  32. Front Side Door Window Regulator Bolt(1)»Remove[5x]

    33. Object ID: 5929564
  33. Front Side Door Window Regulator(1)»Remove
Installation Procedure

    Object ID: 5929564
  1. Front Side Door Window Regulator(1)»Install

    2. Object ID: 5929554
  2. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
    1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
    2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Remove loose debris from internal and external threads using compressed air.
    4. Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation.Adhesives, Fluids, Lubricants, and Sealers

    Caution: Refer to Fastener Caution.

  3. Front Side Door Window Regulator Bolt(1)»Install and tighten[5x]—Fastener Specifications

    4. Object ID: 5929561
  4. Connect the electrical connector.

    5. Object ID: 5929378
  5. Remove the tape holding the front side door window in the full up position and lower the window into the front side door window sash clips.
  6. Front Side Door Window Bolt(1)»Install and tighten[2x]—Fastener Specifications

    7. Object ID: 5928778
  7. Front Side Door Window Channel Retainer(2)»Install
  8. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
    1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
    2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Remove loose debris from internal and external threads using compressed air.
    4. Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation.Adhesives, Fluids, Lubricants, and Sealers
  9. Front Side Door Window Channel Retainer Bolt(1)»Install and tighten[2x]—Fastener Specifications

    10. Object ID: 5879401
  10. Front Side Door Inner Front Panel(1)»Install

    11. Object ID: 5879399
  11. Front Side Door Inner Panel Energy Absorber Bolt(2)»Install and tighten[14x]—Fastener Specifications
  12. Front Side Door Hinge Pin(1)»Install

    13. Object ID: 5890823
  13. With the aid of an assistant, install the front side door.(1)
  14. Connect the wiring harness retainers as necessary.

    15. Object ID: 5893510
  15. Align the front side door roller bolts (1) with the markings made with the grease pencil.
  16. Front Side Door Roller Bolt(1)»Install and tighten[6x]—Fastener Specifications

    17. Object ID: 5892326
  17. Electrical Connector(1)»Connect

    18. Object ID: 5877952
  18. Center Pillar Upper Trim Panel(3)»Install

    19. Object ID: 5891718
  19. Roof Side Rail Outer Extension (1)»Install

    20. Object ID: 5890815
  20. Roof Side Rail Bolt (1)»Install and tighten—Fastener Specifications

    21. Object ID: 5890812
  21. Roof Side Rail Bolt (1)»Install and tighten—Fastener Specifications

    22. Object ID: 5890813
  22. Roof Side Rail Bolt (1)»Install and tighten—Fastener Specifications

    23. Object ID: 5880947
  23. Front Side Door Guide Molding(1)»Install

    24. Object ID: 5880943
  24. Front Side Door Guide Molding Bolt(1)»Install and tighten[4x]—Fastener Specifications

    25. Object ID: 5880881
  25. Front Side Door Guide(1)»Install

    26. Object ID: 5880896
  26. Front Side Door Guide Bolt(1)»Install and tighten[4x]—Fastener Specifications

    27. Object ID: 5880862
  27. Front Side Door Inner Guide(1)»Install

    28. Object ID: 5880865
  28. Front Side Door Inner Guide Bolt(1)»Install and tighten[4x]—Fastener Specifications

    29. Object ID: 5875928
  29. Roof Panel Joint Finish Molding Front End Cap(1)»Install

    30. Object ID: 6196694
  30. Roof Panel Joint Front Finish Molding Retainer(1)»InstallEngage[8x]

    31. Object ID: 6354142

    Note: Quantity of fasteners may vary based on option content.

  31. Roof Panel Joint Finish Molding Nut(1)»Install and tighten[2x]—Fastener Specifications
  32. Ensure the window system operates properly.