
Service Information
2023 BrightDrop Zevo 600 |
Zevo 600 Service Manual (16397800) |
Document ID: 5901462
Battery Negative Cable Extension Cable Replacement - Right Side (Lower Frame to Front Cradle)
Removal ProcedureWarning: Always ensure the Battery Maintenance Mode is inactive before disconnecting the low voltage 12 volt battery (or batteries). This mode can be active with the ignition off, regardless of whether the vehicle charging cord is plugged in or not. When this mode is active, the on-board high voltage battery charger(s) will energize the 12 volt battery cables and
charge the 12 volt battery (or batteries). Disconnecting any battery cables while this mode is active may result in an electrical shock or a burn from hot battery cable leads.
- Check the 12 volt battery voltage with a digital multimeter before disconnecting any battery cable leads. If the voltage is 13.5 volts or above, the Battery Maintenance Mode is active. The technician must wait for the on-board battery charger(s) to deactivate before disconnecting any battery cables.Charging System Description and Operation
- Disconnect the battery negative cable.Battery Negative Cable Disconnection and Connection

Note: Left side shown, right side similar.
- Front Wheelhouse Liner- Right Side(3)»Remove—Front Wheelhouse Front Liner Replacement

- Battery Negative Cable Ground Bolt(1)»Remove[2x]
- Battery Negative Cable Extension Cable(2)»Remove
Installation Procedure

- Battery Negative Cable Extension Cable(2)»Install
- Battery Negative Cable Ground Bolt(1)»Install and tighten[2x]—Fastener Specifications

Note: Left side shown, right side similar.
- Front Wheelhouse Liner- Right Side(3)»Install—Front Wheelhouse Front Liner Replacement
- Connect the battery negative cable.Battery Negative Cable Disconnection and Connection