Radio Replacement (IOS, IOT, IOU)
Removal Procedure

    Object ID: 4596469

    Note: Left side shown, right side similar.

  1. Front Side Door Sill Garnish Molding- Right Side(1)»Remove—Front Side Door Sill Garnish Molding Replacement
  2. Front Floor Panel Carpet - Right Side»Reposition

    3. Object ID: 4583879
  3. Instrument Panel Compartment Door(1)»Remove—Instrument Panel Compartment Door Replacement

    4. Object ID: 6163365
  4. Disconnect all electrical connectors.(1)

    5. Object ID: 6163533
  5. Radio Bracket Bolt(1)»Remove[2x]

    6. Object ID: 6163621

    Note: It is not necessary to completely remove the radio bracket, only reposition as needed.

  6. Release the retaining tabs.
  7. Radio(1)»Remove
Installation Procedure

    Object ID: 6163621
  1. Radio(1)»Install
  2. Secure the retaining tabs.

    3. Object ID: 6163533

    Note: Refer to procedure for tightening sequence and torque values.

  3. Radio Bracket Bolt(1)»Install[2x]—Radio Bracket Replacement

    4. Object ID: 6163365
  4. Connect the electrical connectors.(1)

    5. Object ID: 4583879
  5. Instrument Panel Compartment Door(1)»Install—Instrument Panel Compartment Door Replacement
  6. Front Floor Panel Carpet - Right Side»Install

    7. Object ID: 4596469

    Note: Left side shown, right side similar.

  7. Front Side Door Sill Garnish Molding- Right Side(1)»Install—Front Side Door Sill Garnish Molding Replacement
  8. Perform the necessary programming and setup procedures:Control Module References