Range Selector Lever Cable Adjustment
  1. Remove the engine control module bracket. Engine Control Module Bracket Replacement

    2. Note: Adjust the automatic transmission range selector cable while the transmission and the gear selector are in the Park position only. Failure to do so may cause mis-adjustment

  2. Set the park brake and chock the wheels.
  3. Verify the transmission range select lever is in the park position.
  4. Verify the transmission manual shift lever is in the park position.

    5. Object ID: 4940698
  5. Pull the retaining collar (1) forward.

    6. Object ID: 4940705
  6. Release the range select cable adjusting retainer by pushing it upward (1).

    7. Object ID: 4940707
  7. Slide the two halves (1, 2) of the range select cable together until all free play is removed.
  8. Depress the adjuster retainer (3) locking the adjuster retainer completely.

    9. Object ID: 4940711
  9. Release the retaining collar (1).

    10. Warning: After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.

  10. Pull both halves of the range select cable in opposite directions to verify the cable adjuster is secured.
  11. Check to ensure that all available shift controls operate properly.

    12. Warning: After installing the transmission range selector shift cable, ensure the shifter cannot be shifted out of the Park position unless the brake is applied. Failure to perform this task can result in the shifter moving out of the Park position unintentionally, causing potential vehicle damage and bodily injury.

  12. . Ensure the shifter cannot be shifted out of the Park position unless the brake is applied.
  13. Install the engine control module bracket. Engine Control Module Bracket Replacement