• Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle
• Review the description of Strategy Based Diagnosis:Strategy Based Diagnosis
• An overview of each diagnostic category can be found here:Diagnostic Procedure Instructions

For an overview of the component/system, refer to:Tire Pressure Monitor Description and Operation

Ignition » On / Vehicle » In Service Mode

K9 Body Control Module=Not Learned

• Tire Pressure Sensor 1-4 Identification Code
• All Tire Pressure Sensor Locations Learned

• Tire Pressure Monitoring Indicator=ON
• After the instrument cluster bulb check is complete the tire pressure monitoring system indicator will flash for 1 min and then remain illuminated when the tire type and pressure information is not entered with the scan tool during the body control module setup. If equipped, the driver information center will also display a service message for the tire pressure monitoring system.

A current DTC will be cleared after a successful learn mode.&Ignition Cycled

Control Module References for scan tool information

1. Perform the following learn procedure:Tire Pressure Indicator Sensor Learn.
2. Verify DTC C0775 is not set
• If the DTC is set
1. Verify the component works as specified:T10 Keyless Entry Antenna»Refer to:Keyless Entry System Malfunction.
2. Clear DTCs
3. Verify the DTC does not set.
• If the DTC sets » Replace the component:K9 Body Control Module
• If the DTC does not set

  All OK.

• If the DTC is not set
3. All OK.

Perform the Diagnostic Repair Verification after completing the repair:Diagnostic Repair Verification

For control module replacement, programming, and setup refer to:Control Module References