• Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle
• Review the description of Strategy Based Diagnosis:Strategy Based Diagnosis
• An overview of each diagnostic category can be found here:Diagnostic Procedure Instructions

For an overview of the component/system, refer to:Tire Pressure Monitor Description and Operation

Ignition » On / Vehicle » In Service Mode

The tire type and tire pressure information have not been programmed.

Tire Pressure Monitoring Indicator=ON

A current DTC will be cleared after a successful learn mode.

Tire Pressure Monitor Description and Operation

Control Module References for scan tool information

1. Ignition » On / Vehicle » In Service Mode
2. Program the control module:K9 Body Control Module
3. Program»Tire Type/Pressure Selection»With Scan ToolRefer to:Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label
4. Ignition Off»Ignition » On / Vehicle » In Service Mode
5. Verify DTC C0569 is not set
• If the DTC is set

  Replace the component:K9 Body Control Module

• If the DTC is not set
6. All OK.

Perform the Diagnostic Repair Verification after completing the repair:Diagnostic Repair Verification

For control module replacement, programming, and setup refer to:Control Module References