Carefully push a small nylon wedge between the fascia (1) and the fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia.
Using a trim type tool, release the tabs from the rear body structure stop lamp bracket and carefully pull on the rear bumper fascia (1).
Rear Bumper Fascia(1)»Remove
Disconnect all electrical connectors.
Transfer components as necessary.
Installation Procedure
Rear Bumper Fascia(1)»Install
Connect the electrical connectors.
Note: It is necessary to program all side object sensor modules after removal or transfer for proper system operation.
Secure the rear bumper fascia (1) to the rear body structure stop lamp bracket.
Secure the rear bumper fascia (1) to the rear fascia guide.