Starter Replacement (LTG - All Wheel Drive)

Removal Procedure

  1. Disconnect the battery negative cable.Battery Negative Cable Disconnection and Connection

    2. Object ID: 4574324
  2. Power Transfer Unit Case(2)»Remove—Power Transfer Unit Case Replacement

    3. Object ID: 3903502
  3. Electrical Connector(1)@Oil Pressure Switch(2)»Disconnect
  4. Disconnect the engine harness retainer (3) and reposition the harness.

    5. Object ID: 4631419
  5. Starter Solenoid Cable Nut(2)»Remove
  6. Starter Solenoid Cable(1)»Remove

    7. Object ID: 3903508
  7. Starter Mounting Bolt(2)»Remove[2x]
  8. Reposition the starter (1) to access the electrical connector.

    9. Object ID: 4631424
  9. Electrical Connector(1)»Disconnect
  10. Starter(2)»Remove

Installation Procedure


    Object ID: 4631424
  1. Electrical Connector(1)»Connect
  2. Starter(2)»Install

    3. Object ID: 3903508

    Caution: Refer to Fastener Caution.

  3. Starter Mounting Bolt(2)»Install and tighten[2x] 22 N·m (16 lb ft)

    4. Object ID: 4631419
  4. Starter Solenoid Cable(1)»Install
  5. Starter Solenoid Cable Nut(2)»Install and tighten12 N·m (106 lb in)

    6. Object ID: 3903502
  6. Electrical Connector(1)@Oil Pressure Switch(2)»Connect
  7. Retainer(3)»Engage

    8. Object ID: 4574324
  8. Power Transfer Unit Case(2)»Install—Power Transfer Unit Case Replacement
  9. Connect the negative battery cable.Battery Negative Cable Disconnection and Connection