Airbag Side Impact Rear Sensor Replacement

Object ID: 4602102
Airbag Side Impact Rear Sensor Replacement

Callout

Component Name

Warning: Refer to SIR Warning.

Warning: Refer to SIR Inflator Module Handling and Storage Warning.

Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

  • The seat cushion frame
  • The seat recliner, if equipped
  • The seat adjuster
  • The seat back frame

Failure to do so may cause future personal injury.

    Preliminary Procedures
  1. Disable the SIR system and follow all applicable SIR service precautions.SIR Disabling and Enabling
  2. Quarter Lower Rear Trim Panel Replacement
  3. Reposition the carpet as necessary.

1

Airbag Side Impact Rear Sensor

Caution: Refer to Fastener Caution.

    Procedure
  1. Disconnect the electrical connector.
  2. Loosen the fastener and slide the sensor out of the keyhole slot.
  3. The bolts are integral to the sensor assembly, DO NOT remove separately.
  4. Enable the SIR System.SIR Disabling and Enabling

Note: Integral sensor assembly bolt uses Left Hand threads. Use counterclockwise rotation to loosen fastener at TORX® tip end. If accessing at pan head end of the fastener, use clockwise rotation to loosen bolt.

Tighten

7.5 N·m (66 lb in)