Heater and Air Conditioning Remote Control Replacement (Equinox)

Removal Procedure


    Object ID: 4562630
  1. Instrument Panel Cluster Trim Plate(1)»Remove—Instrument Panel Cluster Trim Plate Replacement

    2. Object ID: 4563532
  2. Instrument Panel Trim Pad - Right Side(2)»Remove—Instrument Panel Trim Pad Replacement - Right Side

    3. Object ID: 4588499
  3. Heater and Air Conditioning User Interface Control(1)»Remove—Heater and Air Conditioning User Interface Control Replacement

    4. Object ID: 4566303
  4. Radio Control Assembly (1)»Remove—Radio Control Assembly Replacement

    5. Object ID: 4590164
  5. Heater and Air Conditioning Remote Control(1)»Remove
  6. Disconnect the electrical connectors.

Installation Procedure

    Note: When reconnecting the module, the BROWN J2 connector must be connected last. Once all the parts are all in place, check and clear all DTCs in the heater and air conditioning remote control.

  1. Connect the electrical connectors.

    2. Object ID: 4590164
  2. Heater and Air Conditioning Remote Control(1)»Install

    3. Object ID: 4566303
  3. Radio Control Assembly (1)»Install—Radio Control Assembly Replacement

    4. Object ID: 4588499
  4. Heater and Air Conditioning User Interface Control(1)»Install—Heater and Air Conditioning User Interface Control Replacement

    5. Object ID: 4563532
  5. Instrument Panel Trim Pad - Right Side(2)»Install—Instrument Panel Trim Pad Replacement - Right Side

    6. Object ID: 4562630
  6. Instrument Panel Cluster Trim Plate(1)»Install—Instrument Panel Cluster Trim Plate Replacement
  7. Perform the necessary programming and setup procedures:Control Module References
  8. Clear the DTCs from the heater and air conditioning remote control module.
  9. Perform the actuator calibration procedure.Actuator Recalibration