Liftgate Power Assist Actuator Replacement

Object ID: 4569094
Liftgate Power Assist Actuator Replacement

Callout

Component Name

Preliminary Procedure

Lower the rear of the headliner to access the connector. Headlining Trim Panel Replacement

1

Liftgate Power Assist Actuator

Warning: When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Caution: DO NOT exceed the limit of the liftgate power assist actuator ball socket joint's free motion during installation to prevent possibility of damage to the actuator.

    Procedure
  1. Disconnect the electrical.
  2. Disconnect the pass through grommet.
  3. Release the strut retainers/clips using a small flat bladed tool to retract clip slightly while removing actuator end from stud.
  4. Install the actuator to the body bracket pivot first and then install to the liftgate pivot.
  5. Ensure the retainer/clip is fully seated when actuator is reinstalled. If clip cannot be fully seated, a new actuator should be installed.
  6. If any portion of the power liftgate assembly is replaced, repaired or disassembled, perform the following liftgate calibration procedure. Liftgate Calibration