• Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle
• Review the description of Strategy Based Diagnosis:Strategy Based Diagnosis
• An overview of each diagnostic category can be found here:Diagnostic Procedure Instructions

DTC P175E is an informational DTC.

• Battery Voltage=Greater than 9 V
• Ignition=On
• Ignition Voltage=Greater than 9 V

Frequency the DTC runs=Continuously—After the running conditions are met—For greater than 2 min

DTCs related to the following system/component = Set—100 Ignition cycles

• B107 Accelerator Pedal Position Sensor
• B14A Transmission Output Shaft Speed Sensor
• B14C Transmission Input Shaft Speed Sensor
• B14D Transmission Intermediate Shaft Speed Sensor
• B26 Crankshaft Position Sensor
• B303 Transmission Range Sensor
• B74 Manifold Absolute Pressure Sensor
• B75 Mass Air Flow Sensor
• Q14 Exhaust Gas Recirculation Valve
• Q17 Fuel Injector
• Q77 Transmission Control Solenoid Valve
• Engine Misfire
• Fuel Trim

DTCs listed in the DTC Descriptor category=Type A DTC

DTCs listed in the DTC Descriptor category=Type A DTC

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Control Module References

1. Verify there are no DTCs set related to the following component/system:
• B107 Accelerator Pedal Position Sensor
• B14A Transmission Output Shaft Speed Sensor
• B14C Transmission Input Shaft Speed Sensor
• B14D Transmission Intermediate Shaft Speed Sensor
• B26 Crankshaft Position Sensor
• B303 Transmission Range Sensor
• B74 Manifold Absolute Pressure Sensor
• B75 Mass Air Flow Sensor
• Q14 Exhaust Gas Recirculation Valve
• Q17 Fuel Injector
• Q77 Transmission Control Solenoid Valve
• Engine Misfire
• Fuel Trim
• If a related DTC is set

  Refer to:Diagnostic Trouble Code (DTC) List - Vehicle

• If a related DTC is not set
2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

   Verify the DTC does not set.

• If the DTC sets

  Refer to step 1

• If the DTC is not set
3. All OK.

Perform the Diagnostic Repair Verification after completing the repair:Diagnostic Repair Verification

For control module replacement, programming, and setup refer to:Control Module References