Rear Wheel Bearing and Hub Replacement (FWD)

Removal Procedure

  1. Remove the rear tire and wheel assembly.Tire and Wheel Removal and Installation
  2. Rear Brake Rotor»Remove—Rear Brake Rotor Replacement

    3. Object ID: 3921364
  3. Rear Wheel Bearing and Hub Assembly Bolt(1)@Knuckle»Remove[3x]

    4. Object ID: 3921367
  4. Rear Wheel Bearing and Hub Assembly(1)»Remove

Installation Procedure

    Note: Avoid applying grease to any other machined surface, holes, or threads. Ensure the drain channel at the bottom of the bore is not blocked with grease or debris.

  1. Apply grease evenly and ensure complete coverage to the knuckle bearing pilot bore only. Adhesives, Fluids, Lubricants, and Sealers

    2. Object ID: 3921367
  2. Rear Wheel Bearing and Hub Assembly(1)»Install.

    3. Object ID: 3921364

    Caution: Refer to Fastener Caution.

  3. Rear Wheel Bearing and Hub Assembly Bolt(1)@Knuckle»Install[3x]
    4. Tighten:
    • First Pass: 100 N·m (74 lb ft)
    • Final Pass: (15–30 degrees)
  4. Rear Brake Rotor»Install—Rear Brake Rotor Replacement
  5. Install the rear tire and wheel assembly.Tire and Wheel Removal and Installation