• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
• Review Strategy Based Diagnosis for an overview of the diagnostic approach.
• Diagnostic Procedure Instructions provides an overview of each diagnostic category.

The electronic brake control module receives serial data messages from other modules. The electronic brake control module must be configured with the Vehicle Identification Number (VIN), configuration data and vehicle options. If not properly configured after installation, the electronic brake control module may set a DTC.

The internal fault detection is handled inside the control module. No external circuits are involved.

Ignition ON

The electronic brake control module is not programmed.

• The traction/stability control indicator turns ON.
• The electronic brake control module disables the traction control, the stability control and the hill start assist for the duration of the ignition cycle.

• The DTC clears when the diagnostic runs and passes.
• The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.

A newly replaced electronic brake control module can set one or more DTCs on its initial ignition ON cycle.

Antilock Brake System Schematics

Master Electrical Component List

ABS Description and Operation

• Circuit Testing
• Connector Repairs
• Testing for Intermittent Conditions and Poor Connections
• Wiring Repairs

Control Module References for scan tool information

1. Ignition ON.
2. Verify that DTC C0569 is not set.
• If the DTC is set
1. Reprogram the K17 Electronic Brake Control Module. Refer to Control Module References.
2. Verity DTC C0569 is not set.
• If the DTC is set, replace the K17 Electronic Brake Control Module.
• If the DTC is not set
3. All OK.
• If the DTC is not set
3. All OK.

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for Electronic Brake Control Module replacement, programming and setup