K111 Fuel Pump Power Control Module: Programming and Setup

This control module does not require SPS programming but does require the following setup procedures after a new control module is installed:

Setup for Component Replacement
  1. Ignition » On / Vehicle » In Service Mode—For 2 min
  2. Ignition/Vehicle » Off—For 2 min
  3. Ignition » On / Vehicle » In Service Mode
  4. Perform the following action:Cylinder Deactivation Exhaust Control Valve Learn(If applicable)
  5. Perform the following action:Clear the DTCs.
  6. Start Engine
  7. Verify DTC P1005 is not set
    • If the DTC sets
    1. Perform the following action:Clear the DTCs.
    2. Ignition/Vehicle » Off—For 2 min
    3. Start Engine
    4. Verify the DTC does not set.
      • If the DTC sets»Repeat the procedure starting at step 1
      • If the DTC is not set»Configuration—Complete
    • If the DTC is not set
  8. Configuration—Complete