Side Object Sensor Module Programming and Setup (Except N America)

Note:

  • DO NOT program a side object sensor – left unless directed to by a service procedure or a service bulletin. If the side object sensor – left is not properly configured with the correct calibration software, the side object sensor – left will not control all of the vehicle features properly.
  • Ensure the programming tool is equipped with the latest software and is securely connected to the data link connector. If there is an interruption during programming, programming failure or side object sensor – left damage may occur.
  • Stable battery voltage is critical during programming. Any fluctuation, spiking, over voltage or loss of voltage will interrupt programming. When required install the EL-49642 SPS Programming Support Tool to maintain system voltage. If not available, connect a fully charged 12 V jumper or booster pack disconnected from the AC voltage supply. DO NOT connect a battery charger.
  • Turn OFF or disable systems that may put a load on the vehicles battery such as; interior lights, exterior lights (including daytime running lights), HVAC, radio, etc.
  • During the programming procedure, follow the SPS prompts for the correct ignition switch position.
  • Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to NO.

Diagnostic Aids

The B218R Side Object Sensor Module – Right is not programmable separately. This module is programmed by B218L Side Object Sensor Module – Left after it has been programmed. If a right side module is replaced, follow this procedure to update the module.

Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing B218L Side Object Sensor Module – Left, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
  2. On the SPS Supported Controllers screen, select B218L Side Object Sensor Module – Left - Programming and follow the on-screen instructions.
  3. At the end of programming, choose the “Clear All DTCs” function on the SPS screen.

Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful programming event, perform the following steps:

  1. Ignition ON. Ensure the B218L Side Object Sensor Module – Left, DLC and programming tool connections are secure and the SPS software is up to date.
  2. Verify the B218L Side Object Sensor Module – Left can be reprogrammed.
    • If the B218L Side Object Sensor Module – Left cannot be reprogrammed
    1. Ignition OFF for one minute, ignition ON.
    2. Verify the B218L Side Object Sensor Module – Left can be reprogrammed.
      • If the B218L Side Object Sensor Module – Left cannot be reprogrammed, replace the B218L Side Object Sensor Module – Left.
      • If the B218L Side Object Sensor Module – Left can be reprogrammed.
    3. All OK.
    • If the B218L Side Object Sensor Module – Left can be reprogrammed
  3. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for side object sensor module – left replacement, programming and setup.