Operating Conditions: Ignition ON

Ignition Cycle Counter

—

Varies

This displays the number of ignition cycles.

Calculated System Temperature

—

Varies

This displays ° C. This is the current system temperature.

Steering Wheel Angle

—

Varies

This displays Degrees. This displays the current steering wheel angle in degrees.

Steering Wheel Input Torque

—

Varies

This displays N·m. This displays the current steering input torque in N·m.

Power Steering Motor Overload Protection Counter

—

Varies

This displays counts. This displays the Electric Power Steering Motor Overload Protection Incidents counter.

Power Steering Control Module SPS Calibration Status

—

True/False

Indicates the completion status of the Electric Power Steering calibration.

Power Steering Control Module Center Procedure

—

True/False

Indicates the completion status of the Electric Power Steering centering procedure.

Vehicle Speed

—

0 Km/h (0 MPH)

This displays km/h (mph). This is the current vehicle speed.

Motor Feedback Current

—

Varies

This displays amps (A). This displays the Electric Power Steering Motor Current Feedback.

Delivered Torque

—

Varies

This displays N·m. This displays the current value of the Output Torque of the Electric Power Steering.

Power Mode

—

OFF/Accessory/Run/Crank Request

This displays system power mode.

Battery Voltage

—

Varies

This displays Volts. This is the current battery voltage.

Clear Driver-Specific Steering Angles

Command to reset the steering rack end of travel limit position as determined by software.

Clear Softstops

Command to reset the steering gear soft end stops as determined by software.

Temporarily Turn Off Active Pull Compensation Function

Command to disable the Active Pull Compensation feature during the key cycle. The power steering control module will return to normal operation with the feature enabled upon exiting the procedure.

Clear Active Pull Compensation Learned Limits

Command to reset the Active Pull Compensation learned values.

Temporarily Turn Off Smooth Road Shake Compensation Function

Command to disable the Smooth Road Shake Compensation feature during the key cycle. The power steering control module will return to normal operation with the feature enabled upon exiting the procedure.

Disable All System Outputs

Command to disable all system outputs of the power steering control module.