• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
• Review Strategy Based Diagnosis for an overview of the diagnostic approach.
• Diagnostic Procedure Instructions provides an overview of each diagnostic category.

For symptom byte information, refer to Symptom Byte List.

Some devices must be configured with serial numbers, vehicle options, or other information. If a device was not properly configured after installation that device may set DTC B1001. The symptom byte information is for engineering reference only. No external circuit diagnosis is involved.

Battery voltage is between 9–16 V and data link communications operate normally.

The device is not configured properly.

• A current DTC clears when the malfunction is no longer present.
• A history DTC clears when the device ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

• Data Communication Schematics
• Control Module References

Master Electrical Component List

Data Link Communications Description and Operation

• Circuit Testing
• Connector Repairs
• Testing for Intermittent Conditions and Poor Connections
• Wiring Repairs

Control Module References for scan tool information

1. Ignition ON/Vehicle In Service Mode.
2. Verify DTC B1001 is not set.
• If DTC B1001 is set
1. Program the device that sets the DTC.
2. Verify the DTC does not set.
• If the DTC sets, replace the device that sets the DTC.
• If the DTC does not set
3. All OK.
• If DTC B1001 is not set
3. All OK

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for device replacement, programming and setup