CH 49375 Wrench

For equivalent regional tools, refer to Special Tools.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
3. Remove the stabilizer shaft link from the strut. Refer to Stabilizer Shaft Link Replacement.
4. Disconnect the head lamp level sensor link from the lower control arm, if equipped. Refer to Headlamp Leveling Front Suspension Height Sensor Replacement.

Note: DO NOT allow the lower control arm and the steering knuckle drop more than 2 inches when the strut assembly has been removed.

5. Support the lower control arm and the steering knuckle.
6. Disconnect the electrical harness/sensor from the strut, if equipped.
7. Remove the front compartment side sight shields. Refer to Front Compartment Side Sight Shield Replacement.



8. Using the CH 49375 wrench, remove the front suspension strut mount nut (1) and the front suspension strut mount washer (2).
9. Remove the front suspension strut bolts (4) and the front suspension strut nuts (3).



10. Remove the front suspension strut assembly (1) from the vehicle.

1. Position the front suspension strut assembly (1) in the vehicle.




Caution: Refer to Fastener Caution.

Note: Ensure that the strut rod does not turn while torquing the strut mount nut to the proper specifications.

2. Using the CH 49375 wrench, install front suspension strut mount washer (2) and the front suspension strut mount nut (1), then tighten the front suspension strut mount nut to 70 N·m (52 lb ft).
3. Install the front suspension strut bolts (4) and the front suspension strut nuts (3).
4. Tighten the front suspension strut bolts to 190 N·m (140 lb ft).
5. Re-connect the electrical harness/sensor from the strut, if equipped.
6. Reconnect the head lamp level sensor link to the lower control arm, if equipped. Refer to Headlamp Leveling Front Suspension Height Sensor Replacement.
7. Remove the support from the lower control arm and the steering knuckle.
8. Install the front stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement.
9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
10. Install the front compartment side sight shields. Refer to Front Compartment Side Sight Shield Replacement.
11. Remove the support and lower the vehicle.
12. Measure and adjust the wheel alignment. Refer to Wheel Alignment Measurement.