Torque Converter Removal

Object ID: 1891302
Torque Converter Removal

Callout

Component Name

1

Lock Pin

Warning: Lock pin must be secured into the bench fixture to hold the transmission and prevent bodily injury.

Note: Ensure the DT-3289-20 holding fixture is mounted to a bench that is properly supported and will support the weight of the transmission assembly without tipping. DT-39890 holding fixture adapter and an engine stand can be used as an alternative method for supporting the transmission assembly during repairs.

    Special Tools:
  • DT-3289-20 Holding Fixture
  • DT-39890 Transmission Holding Fixture Adapter

For equivalent regional tools, refer to Special Tools.

2

DT-21366 Torque Converter Holding Strap

3

Torque Converter Assembly

Caution: Only install the lift assist handles until it stops. Do not tighten. Over tightening the lift assist handles can cause damage to the torque converter.

Note: Failure to raise the torque converter straight up could damage the torque converter clutch lip seal inside the torque converter clutch assembly.

Special Tool

DT-46409 Torque Converter Lifting Handles

For equivalent regional tools, refer to Special Tools.