Diagnostic Repair Verification

Note: After a repair has been made, some DTCs require the ignition to be turned Off and then back On before the scan tool function will clear the DTC.

  1. Ignition/Vehicle » Off
  2. Install any components or connectors that have been removed or replaced during diagnosis.
  3. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
  4. Perform the following action:
    1. Ignition » On / Vehicle » In Service Mode
    2. Clear the DTCs.
    3. Ignition/Vehicle » Off
    4. Driver Door»Open&Close
    5. Wait for greater than 2 min.orInstrument Panel=Off
  5. Perform the Circuit/System Verification and verify the result ends with an All OK—If available

    or

    If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not set.If the DTC sets or another DTC is present » Refer to:Diagnostic Trouble Code (DTC) List - Vehicle

    or

    If the repair was symptom related, duplicate the conditions under which the customer concern occurred to verify the repair.If the customer concern reoccurs or another symptom is present » Refer to:Symptoms - Vehicle